WolfVision VZ-C12³ Service Manual download pdf (Page 7)

1. Connect the power cable to the unit (#11) and plug it in

2. If you would like to use a control monitor, connect it to

the PREVIEW RGB output (#17)

3. Connect a large viewing monitor or a projector to one of

the outputs of the Visualizer

For choosing the right output mode please see page 15!

4. Turn the main power switch (#8) on the unit to "I".

The power indication LED on the unit is illuminated red

to indicate that power is supplied.

5. Press the POWER key (#40) on the remote control

The Visualizer now runs the “power-on preset”.

When the Visualizer is switched on the first time, the Quick Setup Guide will be started automatically (on-

screen menu). The settings are: Language, Ethernet Settings, Time Settings and the Height Adjustment.

The Ceiling Visualizer is pre-set to a distance of 2 m (78.76"). In most installations the installation height will

be different to this, so the following adjustments must be performed:

1. Adjustment of camera and light focus

2. Alignment of lightfield and camera field

NOTE: The Height Adjustment is a one time setup, which must only be performed again if the distance

between the Visualizer and table is changed! - more details in the installation manual

Basic Preparations

The Unit Is Switched On The First Time

Power-on preset:

Automatically zooms to a middle zoom position, focuses on the working surface and activates the auto iris

(the pick-up size is dependent on the mounting height of the Visualizer).

As soon as the Power Indication LED is green and stays illuminated, you can start working with the

Visualizer. The behavior of the unit once the power has been supplied or after the POWER key has been

pressed can be changed in the unit's on-screen menu (see page 16).

1 2 3 4 5 6 7 8 9 10 11 12 ... 43 44

No comments

WolfVision VZ-C12³ Service Manual Page 7