WolfVision VZ-8plus User Manual download pdf (Page 2)

Page-Commands

The commands are split into two pages (because for one command-page there are too many

commands exist). Basically each command is a two Byte command, page-command + control-

command.

If the command-reply mode is switched on, then the Visualizer sends a reply for each Byte, a reply

for the control-command and also for the page-command (for details see “Reply Mode Control”).

The standard command page is "0", that means, if you want to execute a command from the page

"0" (standard page), then it's not necessary to select the page "0" before. If you want to execute a

command from the page "1" then you must select the page "1" and input now your command.

If the page "1" command is executed, then the Visualizer switches automatically back to the page

"0".

Check "Page" column for command page in the following tables.

Select Page Control

Page Dec.

Code

Hex.

Code

Command Description see

Notes

0 048 $30 SER_Page0 By sending this command the Visualizer switches

to the page "0" and waits for the control

command.

Page "0" is the standard page and it is not

necessary to select it

0 049 $31 SER_Page1 By sending this command the Visualizer switches

to the page "1" and waits for the control

command.

After the control command is executed (i.e. 136

for Show All) the Visualizer changes back to the

standard page (page 0)

T-01-04.RS232 Protocol VZ-8_plus_light.doc Page 2

1 2 3 4 5 6 7 ... 17 18

No comments

WolfVision VZ-8plus User Manual Page 2