ENGLISHRCheck out our Internet Homepage for additional information at: http://www.wolfvision.com/supportVZ-27 / VZ-57VZ-27 / VZ-57INSTRUCTIONSINST
109-IMAGE MEMORYTEXT ENHANCEMENTIMPORTANTFor improving the readability of text, sketches and x-rays press the TEXT-key (#16). This mode enhances the c
INFRARED REMOTE CONTROLIf the Visualizer can only be controlled from a close distance or if it cannot be controlled at all with the infrared remote co
TRANSPORTATIONIMPORTANTIMPORTANTIn order to prevent damage to the mirror during transportation, alway put the supplied mirror protection cover on the
WHITE BALANCE ADJUSTMENTEach time the lighting condition changes, the user should adjust the white balance of the Visualizer's camera, in order t
DVI PORT SERIAL PORT / SERIAL PROTOCOLPins: 2:RX, 3:TX, 5:GND9-pin D-Sub connector on unit, male, front sideA detailed description of th
All measurements in MillimetersTECHNICAL DATADIMENSIONS28 to 40mm requiredfor cablesCooling Air InletCooling Air OutletIMPORTANT NOTE: DO NOT BLOCK CO
TROUBLESHOOTINGSymptoms: Check points:No power- Is the main power switch (# 34, on the back of the unit) switched to "I"?- Check fuse (#35)
Printed in Austria - January 2003RStoring presets:Auto focus for flat objects:Press a PRESET key (14) for 2 secPress MENU key (23) for 1 secSync on gr
FCCThis equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits
CONTENTS:CONTACTS:Manufacturer: WolfVision GmbH, Vlbg. Wirtschaftspark, A-6840 Götzis / AUSTRIA, Tel. ++43-5523-52250, Fax. ++43-5523-52249, E-Mail:
#1 Arm#2 Base mirror#3 Top mirror#4 Control pannel#5 Synchronized lightfield (Top light)#6 Remote Control#7 Ventilation#8 Air extracti
#34 Main POWER switch#35 FUSE (see page 12)#36 POWER connection#37 DVI output (see page 14)#38 USB port (see page 9)#39 SERIAL port for external
aecbfgdHOW THE VISUALIZER WORKSBASIC PREPARATIONS1. Connect the power cable to the unit (#36) and plug it in.2. If you would like to use a control m
1. Place your subject material on the working surface. A synchronized lightfield on the working surface marks the pick-up area of the built-in came
BOTTOM LIGHT / LASER CENTER MARKER (VZ-57)The LIGHT key (#21) of the VZ-57 and VZ-27 can be used to switch between: "Top light" (with Syn
PRESET FUNCTIONWolfVision Visualizers offer the possibility of programming three presets for the functions: Zoom, Focus, Iris, Light, Image, Text, Mac
Comments to this Manuals